Tag Archive:window tips

Bymwmcleod

Choosing The Right Glass for Your Home

Are you too hot in the summer and cold in the winter? Does your carpet fade? Are your energy bills too high? These are the concerns we most often hear from homeowners when they ask us about purchasing new windows. We hear you, the quality of windows can impact your lifestyle and home in many ways. So if the time has come to replace the windows in your home, here are some helpful points that will help guide your window selection.

Exterior of Home with Marvin Windows

The direction your home faces impacts the type of window you should purchase.

What to consider when you purchase a window:

Geographic Orientation. How many windows are facing East, West, North and South? Since the sun rises in the East, our homes see the most of hot midday sun on the East and South facades. North and West facing windows tend to lose a greater amount of heat through the glass.
Shading.  Overhanging awnings and landscaping can offer protection from the sun’s thermal radiation in the summer. In the winter, they can still allow the benefit of the solar heat gain when the sun’s orientation is lower on the horizon. This solar heat gain is free energy in those winter months, reducing the load on your heating system and saving you money on your energy bills.

Coating. There are two types of Low-E (Emissivity) that were developed to decrease the amount of ultraviolet light (causes interior materials to fade) and infrared light (heat energy).

Passive Low E (Hard Coat) – This type of coating is applied to the glass in its molten stage, so it becomes fused to the glass. It allows higher levels of solar heat gain but will reflect a good portion of the heat back into your home.

Solar Control Low E (Soft Coat) – Solar Control Low E coating is applied to the finished glass by a process called ‘sputtering’. This coating has superior solar control performance and is typically used for windows that are fully exposed to the East and South facing sun. It does have a slightly darker tint than Passive Low E coatings, as they have 2-3 layers of film applied to the glass. The final result, however, is full transparency.

90% of your window is made of glass.

You probably thought it was 100%, didn’t you? But the other 10% is actually made up of different glazing and coating that is used to provide the comfort and  efficiency you desire.

With these points in mind, it is important to speak with your architect, contractor or one of the window experts here at McLeod Windows. We’ll help ensure you get the best glass for your windows and doors.

Bymwmcleod

Window Tips: How to Drain Water

Tracking at bottom of window

Tracking at bottom of window

Here are a few simple steps on how to maintain the performance of your windows.

Windows, doors and skylights often have a simple drainage system that allows accumulated water to drain to the exterior of the building. Sometimes this is called a “weep” system.

To get the most out of this system, the drainage pathways must be kept clean and clear.

• Some products are designed with sloped sills to allow
the water to leave. It’s normal for water to accumulate
in the sill or track area with wind-driven rain.

• Keep sill or track areas clean of dirt or debris.

Cross-section of a window.

Cross-section of a window.

• Make sure that the outside and inside weepholes and
sill areas are kept clear of any  stucco, paint,
sealants, roofing cement or any other building materials.
Use a small, soft bottle brush or dry paint brush to clear
openings.

• If the weepholes contain drainage covers, called baffles,
they should move freely, to allow water drainage and help
reduce air infiltration. If the baffles do not move freely or
there is build-up of dirt and debris behind them, carefully
remove the baffle with a flat screw driver, flush the dirt
and debris and replace the baffle.

Come back often to mcleodwindows.com to learn more window maintenance tips!